ABAP Process Type is in Yellow though its cancelled

Hi,

I am using process type ABAP in process chains. When any of the ABAP program fails/cancel; I was expecting the chain to show red status immediately.

But this is not the case. When any program fails its status will still be in yellow for a particular amount of time (not sure where is that setting) and the process will be shown as running.

Now when I open the log in RSPC and do a refresh; it will show the status red as failed. But if I do not refresh in RSPC and just monitor from RSPCM; or if adding a message on step failure. It takes a while to show the process chain failed.

Please let me know if there is any such setting or time interval is generally defined to wait for the process type to become red; and if yes where can I check that. Thanks.

Image may be NSFW.
Clik here to view.

Regards,

Anil